S-8000L Specifications

1. Support 32-65536 level grayscale, correcting with software Gamma.
2. Support various point, line and area light sources, various rules and special-shaped processing.
3. Support 8 output ports, each can carry a maximum of 512/1024 lamps (three channels), and enhance TTL and DMX512 signal output.
4. The play content can be stored in SD card, which can store up to 32 effect programs.
5. Support 32 SD effects (only supports four-channel effects), and various lamp control chips.
6. DMX512 console is connected to the S-8000L controller through the XLR line or network cable, and the console sends commands to control the controller mode, speed, lighting color change, etc.
7. The S-8000L controller can be used alone or in cascade. The cascade adopts the photoelectric isolation method, featuring anti-interference and better stability.
8. Built-in 16 test effects and support three/four-channel play.
9. Edit the effect by using the software of master controller (can modify the channel sequence), and select K-8000-L-RGB/RGBW to change the effect.

Note: 1. The speed of 512 pixels of lamps on the controller can reach 30 frames/second, the speed of 768 pixels can reach 25 frames/second, and the speed of 1024 pixels can reach 22 frames/second (The above parameters take the IC data of 1903 protocol as an example, and the data may be different for different ICs)

2. A maximum of 512 pixels of international standard DMX512 (1990 protocol) can be loaded. When the load is the international standard 170 pixels, the speed can reach 30 frames/second, the speed of 340 pixels is about 20 frames/second, and the speed of 512 pixels is about 12 frames/second.

Front view:

Side view 1:

Side view 2:

http://www.fsleds.com/